qclone doesn't work on 0.9.4?
Peter Arrenbrecht
peter.arrenbrecht at gmail.com
Thu Mar 6 00:49:17 CST 2008
Three things:
* Plain `hg serve` does not publish the .hg/patches subrepo and so
qclone cannot see it.
* `hg serve` with [collections] only recently learned to publish
.hg/patches subrepos automatically.
* qclone has only very recently learned to clone remote repos with
applied patches properly.
So you need to wait for a more current version of hg for the last two.
Meanwhile: If you publish the repo in a `hg qpop -a` state, and run hg
serve with a [paths] setting that lists both the repo and its
.hg/patches, then it should work properly even on 0.9.4.
-peo
On Thu, Mar 6, 2008 at 12:54 AM, Neo Jia <neojia at gmail.com> wrote:
> hi,
>
> I am trying to use qclone to clone my repository with patches repo.
> inside created by "hg serve". It works fine if I just qclone the
> repository locally without "http://".
>
> But it failed to clone the patches repository when I am trying to use
> the source remotely. Even worse, it duplicates the whole source code
> repository inside the .hg/patches directory.
>
> Can anyone verify that?
>
> thanks,
> Neo
>
> --
> I would remember that if researchers were not ambitious
> probably today we haven't the technology we are using!
> _______________________________________________
> Mercurial mailing list
> Mercurial at selenic.com
> http://selenic.com/mailman/listinfo/mercurial
>
More information about the Mercurial-devel
mailing list