D2806: tweakdefaults: add commands.status.verbose to tweakefaults

durin42 (Augie Fackler) phabricator at mercurial-scm.org
Tue May 8 00:28:39 EDT 2018

durin42 added inline comments.


> martinvonz wrote in ui.py:66
> I didn't notice this had changed until now. I've run `hg bisect --bad` to start bisecting twice in the last week or so and hg replies with "The first bad revision is:" etc.  Of course, the reason that happens is because I had not cleared the bisect state from last time. I wonder if we should remove this line since it seems better for new users to include the bisect state reporting and advanced users who have gotten used to running `hg bisect --reset` to start bisecting can instead set the config. What do you think? Augie, how about you (it's you I had in mind with "advanced users can turn it off" :))?

As long as skipstates is reasonably documented, I'm okay with this.

(I might even leave it on, given this good defense of an annoying feature.)

  rHG Mercurial


To: pulkit, #hg-reviewers, durin42
Cc: martinvonz, mercurial-devel

More information about the Mercurial-devel mailing list